Installing The Rear Shock Absorber Assembly - Yamaha WR250F Owner's Service Manual

3. Install:
• Bearing "1"
• Oil seals "2"
New
(to connecting arm "3")
Installed depth "a"
0 mm (0 in)
2
1
a
a
1
2
INSTALLING THE REAR SHOCK ABSORB-
EAS2GB2217
ER ASSEMBLY
1. Lubricate:
• Bearing (lower side)
• Dust seal
• Collars
• Bushing
Recommended lubricant
Molybdenum disulfide grease
ECA
NOTICE
Do not apply the grease to the bearing outer
race because it will wear the rear shock ab-
sorber surface on which the bearing is
press fitted.
2. Lubricate:
• O-ring
Recommended lubricant
Lithium-soap-based grease
3. Install:
• Bearing
• Stopper ring
New
(to rear shock absorber assembly (upper
side))
TIP
• Install the bearing parallel until the stopper
ring groove appears by pressing its outer
race.
• After installing the stopper ring, push back the
bearing unit it contacts the stopper ring.
REAR SHOCK ABSORBER ASSEMBLY
3
5-62
4. Install:
• Bearing "1"
• Bushing "2"
• Collar "3"
• Dust seal "4"
(to rear shock absorber assembly (lower
side))
TIP
Install the dust seals with their lips facing in-
ward.
Installed depth "a"
4.25 mm (0.17 in)
5. Lubricate:
• Connecting arm and frame bolt
• Relay arm and connecting arm bolt
• Relay arm and swingarm bolt
(circumference and threaded portion)
• Rear shock absorber assembly upper bolt
• Rear shock absorber assembly lower bolt
Recommended lubricant
Molybdenum disulfide grease
6. Install:
• Rear shock absorber assembly
TIP
• When installing the rear shock absorber as-
sembly, lift up the swingarm.
• Install the rear shock absorber assembly up-
per bolt, and connecting arm bolt (frame side)
from the right.
• Install the rear shock absorber assembly low-
er bolts, connecting arm bolt (relay arm side),
and relay arm bolt (swingarm side) from the
left.
7. Tighten:
• Rear shock absorber assembly upper bolt
Rear shock absorber assembly
upper bolt
56 Nm (5.6 m·kgf, 41 ft·lbf)