Yamaha SXV70SJ Supplementary Service Manual page 391

1 Wire harness
2 Ensure this is not kink.
3 50 mm (1.97 in)
4 Make sure that the oil tank cap
and oil tank breather hose do not
touch each other.
5 Route the fuel tank breather hose
over the main switch wire
harness.
6 Route the oil tank breather hose
over the main switch wire
harness.
7 Install the tail/brake light lead
behind the instrument panel.
8 When fastening the tail/brake
light lead with the attached
clamp, bend the clamp inward to
fasten it.
9 Fasten the oil tank breather hose,
fuel tank breather hose and wire
harness at the inside of the
instrument panel screw with a
plastic band.
; Route the tail/brake light lead
between the fuel tank and the
snowmobile body. Make sure that
the fuel tank does not crush the
tail/brake light lead. Then, fasten
the three pieces of adhesive tape
below the fuel tank as shown.
A Adhesive tapes
B To the tail/brake light
C Pass the wire harness and fuel
tank breather hose through the
cable holder.
D Fuel sender coupler
E Install the metal clip facing
downward.
F Insert the fuel tank breather hose
until it can not be inserted further.
G Oil level switch coupler
H Fuel delivery hoses
I Vacuum hose
J Oil delivery hose
CABLE ROUTING
9-30
SPEC