Yamaha SXV70SJ Supplementary Service Manual page 108

Clamp the main wire harness,
1
coolant hose and throttle posi-
tion sensor behind the throttle
position sensor coupler. Point
the tip of the clamp to the intake
silencer side.
Throttle position sensor
2
Joint connecter
3
Starter cable
4
Throttle cable
5
Pass the oil pump cable through
6
the outside of the starter cable.
Route the CDI magneto lead
7
coupler and boot along with the
coolant hose.
Ignition coil lead coupler
8
T.O.R.S. lead connector
9
Coolant sensor coupler
10
Main harness
11
Main harness from the starter
relay to the starter motor.
Starter motor
12
(For model with starter motor)
Pass the main harness under the
13
carburetor heater hose.
Housing cap
14
Clamp the main harness and the
15
metal section of the brake hose.
Brake hose
16
Battery negative lead
17
(For model with starter motor)
Coolant hose
18
Starter relay lead
19
(For model with starter motor)
Battery positive lead
20
(For model with starter motor)
Main harness from the starter
relay to the starter motor.
Clamp the main harness.
21
(For model with starter motor)
Point the tip of the clamp to the
22
outside of the vehicle.
Cover
23
CDI magneto lead
24
Throttle position sensor lead
25
CABLE ROUTING
–102–
SPEC