Throttle Cable Free Play Adjustment - Yamaha SXV70SJ Supplementary Service Manual

THROTTLE CABLE FREE PLAY ADJUSTMENT

COOLING SYSTEM/
S Add coolant to the coolant cold level a .
S Loosen the bleed bolt 2 .
S Drain the coolant until no more air bubbles ap-
pear.
S Tighten the bleed bolt 2 .
Bleed bolt:
3.5 Nm (0.35 mSkg, 2.5 ftSlb)
S Install the coolant filler cap.
Apply and lock the parking brake. Start the en-
gine and run it at approximately 2,500 X 3,000
r/min until the coolant circulates (approxi-
mately 3 X 5 minutes). The side heat ex-
changers will be warm to the touch.
WARNING
To avoid severe injury or death:
S Make sure the machine is securely sup-
ported with a suitable stand.
S Do not exceed 3,000 r/min. Drive line dam-
age and excessive V-belt wear could occur,
or the machine could unexpectedly move
forward if the clutch engages.
S Operate the engine only in a well-ventilated
area.
S Remove the coolant filler cap and bleed the
cooling system again, as described above.
No air bubbles ! OK.
S Add coolant to the specified level.
3. Install:
S Rear bumper cover
S Seat
THROTTLE CABLE FREE PLAY
ADJUSTMENT
NOTE:
S Before adjusting the throttle cable free play,
the engine idle speed should be adjusted.
S Adjust the throttle cable free play while the
cable is in the cable guide.
1. Measure:
S Throttle cable free play a
Out of specification ! Adjust.
Throttle cable free play:
1.0 X 2.0 mm (0.04 X 0.08 in)
–7–
INSP
ADJ