ALIBI ALI-NP3016RH Quick Installation Manual

ALI-NP3016RH 6.0 MP IP Bullet
Camera Quick Installation Guide
This document guides you through the basic steps to install and configure the ALI-NP3016RH camera. The
camera features:
6.0 MP high resolution sensor
•
2.8 - 12 mm motorized vari-focal lens
•
HD real-time video up to 3072 x 2048 with tri-streaming and H.264 compression
•
Smart IR LED array with illumination up to 165 feet
•
3D-DNR noise reduction, digital Wide Dynamic Range (WDR)
•
Dual power capable - Power over Ethernet (PoE) or 12 Vdc
•
Weatherproof - IP67 rated
•
Internal microSD card storage up to 128GB (card not provided)
•
2-way Audio I/O, Alarm I/O
•
For more information about the software features of this camera, please refer to the ALILBI IP Camera V3
Software User Manual, available from your retailer.
Articulated
mounting
bracket
Camera body
12 Vdc,power
and ground
terminations
www.observint.com
1
Junction box assembly
(see detail below)
Camera mounting base
Sun Shield
Safety cable
Alarm In/Out
terminals
LAN (RJ-45)
connector
Audio In/Out
connectors CVBS Out
microSD card slot and reset button inside.
Camera base
locator pins
Top (up)
Bottom (down)
Conduit port (2)
What's in the box
Your camera includes the following items:
CD-ROM with manuals and ALIBI Power Tools
•
utilities
Drill template
•
Waterproof RJ-45 LAN coupling
•
Junction Box
•
Gang box adapter plate (not shown)
•
Security wrench
•
Mounting hardware
•
Step 1.

Install the camera

Lens
The camera includes hardware to install it directly to the Junction box provided, to a mounting surface
(without the junction box), or to a double-gang electrical box using the adapter plate provided. When
using the junction box, camera LAN and power drop cables can attach to extension cables inside the box.
The camera with or without the junction box can be installed on a ceiling (horizontal surface) or wall
(vertical surface). To install the camera, do one of the following:

To mount the camera using the Junction box

1. Remove the cover on the underside of the camera, and then install a microSD card. The card can
have a capacity up to 128 GB. Reinstall the cover.
2. Determine the best fasteners for securing the Junction box to mounting surface. The mounting
hardware provided is suitable for most surfaces.
3. Remove the junction box from the camera assembly by loosing the four captive screws.
4. Attach the drill template to the surface. Mark the location of the Junction box mounting screw
holes. If routing extension cables for the LAN, power, alarm devices, etc. through the mounting
surface, mark the location for that hole too. NOTE: When installing the box onto a wall, observe the
orientation for TOP and BOTTOM orientation markings inside the box and on the camera mounting
base, and orient the drill template properly.
Mounting surface
Drill template
Junction box mounting screws (4)
Junction box detail
Waterproof LAN coupling
Junction box
Safety cable
Orientation mark
Mounting base screws (4)
Hook for safety
cable
Mounting screw
hole (4)
Hole for camera
mounting screw (4)
Cable access
through mounting
surface
Camera
ALI-NP3016RH_CQ
10/13/15