This document guides you through the basic steps to install and configure the ALI-NS2122VR network
vari-focal dome camera. This camera features:
1/2.8" 1920 × 1080 pixel Progressive Scan CMOS
•
2.8 ~ 12 mm motorized vari-focal lens
•
H.265, H.265+, H.264+, H.264 video compression
•
120 dB Wide Dynamic Range
•
Back light compensation (BLC) / 3D dynamic noise reduction (DNR) / region of interest (ROI)
•
IP67, IK10 vandalproof rated
•
Compatible with the ALI-AF11 Flange Adapter
•
4 behavior analyses and face detection
•
For more information, refer to these documents - available from your equipment vendor:
ALIBI™ Tools Utility Installation and User Manual
•
ALIBI™ Witness 2.0 r3 App for Android or iOS Quick Start Guide
•
ALIBI™ IP Camera Firmware Version 5.4 User Manual (or later) provided at:
•
AlibiSecurity.com/resources
Adapter plate
and junction box
Camera body
Dome
cover
screws
Dome
Lens
Connector for BNC video cable
Gimbal
camera
mount
Maintenance panel
(microSD slot, RESET)
Camera without dome assembly
1
www.observint.com
ALI-NS2122VR 2MP Vari-focal IP Dome Camera Quick Installation Guide
Dome assembly
Motorized zoom lens
Dome safety cable
Captive screw for
junction box (3)
Screw stud for
junction box (3)
Conduit
adapter
Hole for
through-
surface cable
routing
Adapter plate (camera side)
Ground terminal
Junction box (adapter plate side)
Captive screws connect
Sealing plug
to adapter plate (3)
for interface wiring (5)
Seal (black)
Junction box (inside view) with adapter plate
Connector block terminals for
alarms, audio, LAN, power
Side inlet
Inside camera base (junction box removed)
Screw holes for
double-gang box
mounting - #2 (4))
FRONT
Screw holes for single-
gang box mounting #1 (2)
Sealing plug
for interface wiring (5)
Sealing plug
for LAN cable
Safety cable
Junction box
Adapter plate
Hook for safety cable
ALI-NS2122VR_CQ
Side
inlet
cover
180904
Need help?
Do you have a question about the ALI-NS2122VR and is the answer not in the manual?
Questions and answers