1
Installing the Roll Bar
Parts needed for this procedure:
1
Roll bar
4
Bolt (1/2 x 3-3/4 inches)
4
Flange-nut (1/2 inch)
Procedure
1. Remove the top crate support from the crate.
2. Remove the roll bar from the crate.
3. Install the roll bar into the pockets on each side of
the machine, using 4 bolts (1/2 x 3-3/4 inches) and 4
flange-nuts (1/2 inch)
1. Roll bar
2. Bolt (1/2 x 3-3/4 inches)
4. Torque the fasteners to 136 to 149 N-m (100 to 110
ft-lb).
(Figure
3)
1
2
3
g014601
Figure 3
3. Flange-nut (1/2 inch)
2
Installing the Seat
Parts needed for this procedure:
1
Seat
1
Seat wiring harness
Procedure
Note: Mount the seat in the front set of mounting holes to
gain an additional 7.6 cm (3 inches) in the forward adjustment,
or in the rear mounting holes for an additional 7.6 cm (3
inches) in the rearward adjustment.
1. Remove and discard the lag bolts securing the seat
slides and cut the shipping straps.
2. Remove the 4 bolts (5/16 x 3/4 inch) and washers
from the shipping bracket and discard the bracket.
3. Secure the seat to the seat base with 4 bolts and washers
removed previously
5
1
2
3
4
1. Seat
2. Seat base
3. Washer
12
(Figure
4).
g016317
Figure 4
4. Bolt (5/16 x 3/4 inch)
5. Install the seat using these
holes.