Inspecting And Cleaning After Mowing; Towing The Machine - Toro 04530 Operator's Manual

1. Trailer
2. Full-width ramp
Inspecting and Cleaning After
Mowing
At the completion of the mowing operation, thoroughly
wash the machine with a garden hose without a nozzle so
excessive water pressure will not cause contamination and
damage to the seals and bearings. After cleaning, inspect the
machine for possible hydraulic fluid leaks, damage or wear
to hydraulic and mechanical components, and the cutting
units for sharpness. Also, lubricate the mow and lift pedal
and brake shaft assembly with SAE 30 oil or spray lubricant
to deter corrosion and help keep the machine performing
satisfactorily during the next mowing operation.

Towing the Machine

In case of an emergency the machine can be towed for a short
distance (less than 0.4 km (1/4 mile)). However, Toro does
not recommend this as standard procedure.
Important: Do not tow the machine faster than 3-5
km/h (2-3 mph) because the drive system may be
damaged. If the machine must be moved a considerable
distance, transport it on a truck or trailer.
1. Locate the bypass valve on the pump and rotate it so
that the slot is vertical
Figure 39
3. Not greater than 15
degrees
4. Full-width ramp—side
view
(Figure 40).
1. Bypass valve-slot shown in closed (horizontal) position
2. Before starting the engine, close the bypass valve by
rotating it so that the slot is horizontal
not start the engine when the valve is open.
34
Figure 40
(Figure
1
g014627
40). Do