Specifications; Attachments/Accessories; Operation; Think Safety First - Toro 04530 Operator's Manual

side of the machine. Plug the connectors together before
operating the machine.
Figure 27
1. Cutting unit power disconnect connector
CAUTION
If you do not disconnect the power to the cutting
units, someone could accidentally start the cutting
unit, causing serious injury to hands and feet.
Always separate the cutting unit power disconnect
connectors before working on the cutting units.

Specifications

Note: Specifications and design are subject to change
without notice.
Width of cut
Wheel tread
Wheel base
Overall length (w/baskets)
Overall width
Overall height
Weight

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
151 cm (59.5 inches)
128 cm (50.5 inches)
119 cm (46.9 inches)
249 cm (98.0 inches)
179 cm (70.62 inches)
205 cm (80.83 inches)
Refer to the machine serial
tag (Figure 1).

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions and symbols
in the safety section. Knowing this information could help
you or bystanders avoid injury.
The use of protective equipment, such as but not limited to,
for eyes, ears, feet, and head is recommended.

Checking the Engine Oil

The engine is shipped with 1.65 liters (1-3/4 quarts) (w/filter)
of oil in the crankcase; however, the oil level must be checked
before and after the engine is first started.
The engine uses any high-quality detergent oil having the
American Petroleum Institute (API) service classification of
SG, SH, or SJ or higher. The recommended viscosity (weight)
is SAE 30.
1. Position the machine on a level surface.
2. Unscrew the dipstick and wipe it with a clean rag.
Screw the dipstick into the tube and make sure it is
seated fully (Figure
2
1. Dipstick
3. Unscrew the dipstick out of the tube and check the
oil level.
4. If the oil level is low, remove the filler cap from the
valve cover and pour oil into the opening in the valve
cover until the oil level is up to the Full mark on the
dipstick. Add the oil slowly and check the level often
during this process. Do not overfill.
25
28).
1
Figure 28
2. Filler cap
g016292