Toro 04530 Operator's Manual page 30

CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
1
Figure 32
1. Footrest—closed
3. Position the cutting unit under the center suspension
arm.
4. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure
down so that the bar fits over the bar across the top of
the cutting unit (Figure
1
Figure 33
1. Latch—closed position
2. Suspension-arm bar
2
2. Footrest—open
33), push the suspension arm
34).
2
3. Latch—open position
1
2
g014602
1. Suspension-arm bar
5. Close the latches down and around the cutting-unit bar
and lock them in place
Note: A "click" can be heard and felt when the latches
are properly locked in place.
6. Coat the spline shaft of the cutting unit motor with
clean grease
7. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
3
of the motor
g014609
30
Figure 34
2. Cutting-unit bar
(Figure 33).
(Figure 35).
(Figure 35).
g01461 1