Toro 04530 Operator's Manual page 24

Seat-Adjusting Lever
The seat-adjusting lever is located on the front, right corner
of the seat (Figure 24), allowing you to adjust the seat fore
and aft. Push the lever to the left (towards the center), to
release the lock and slide the seat.
Note: If you need additional adjustment on the seat, you can
remove the four bolts securing the seat to the base and move
the seat to the second set of mounting holes provided.
1
Figure 24
1. Seat-adjusting lever
Note: Before lifting the seat, slide it to the furthest back
position and move the steering arm fully forward.
Fuel-Shutoff Valve
Close the fuel-shutoff valve
under the fuel tank when storing or transporting the machine
on a truck or trailer.
g014628
(Figure 25) behind the seat and
1. Fuel shutoff (under the fuel tank)
Parking-Brake Lever
Pull up on the brake lever
Disengage it by pulling up on the release latch and lowering
the brake handle. Lock the parking brake any time you leave
the machine.
1. Parking-brake lever
Cutting Unit Power Disconnect
Before installing, removing, or working on the cutting
units, disconnect the cutting units from the power supply
by separating the cutting unit power disconnect connector
(Figure 27), located at the base of the rollover bar on the left
24
1
g01462 6
Figure 25
(Figure 26) to set the parking brake.
Figure 26
2. Release latch