Installation; Loose Parts - Toro 79366 Operator's Manual

Installation

Loose Parts

Note: A rear–mount Attach-A-Matic
which must be purchased separately, are required to operate the tractor equipped with this snowthrower.
Use the chart below to identify parts used for assembly.
**Rear wheel weights may not provide adequate traction under some conditions or on inclines. If these
conditions exist, a rear weight box is recommended.
DESCRIPTION
Snowthrower frame assembly
Lift tube
Clevis pin 1/2" x 2 5/8" (67 mm)
Clevis clip
Discharge chute assembly
Washer 5/16" (8 mm)
Locknut 5/16"
Carriage bolt 5/16–18 x 3/4" (19 mm)
Clevis pin 3/8" x 1" (25 mm)
Hairpin cotter—small
Pulley box
Belt
hitch, rear wheel weights (and/or rear weight box**) and chains, all of
QTY.
1
1
Attach lift tube
1
1
1
3
Assemble discharge chute
3
3
2
Prepare tractor attachment lift
2
1
Install pulley box
1
USE
3