Toro 79366 Operator's Manual page 15

1
Figure 25
Right side of tractor shown
1. Spring tension link
2. Spring tension lever
3. Remove the snowthrower belt from the engine
PTO pulley:
A. Open the hood of the tractor
B. Remove the right–hand side panel.
POTENTIAL HAZARD
Components under the hood will be hot if
the tractor has been running.
WHAT CAN HAPPEN
Touching hot components can cause burns.
HOW TO AVOID THE HAZARD
Allow the tractor to cool before performing
maintenance or touching components
under the hood.
C. Remove the snowthrower belt from around
the engine PTO pulley (Fig. 26).
Note: Lifting up on the spring–loaded pulley
will ease removal of the belt.
4
2
m–4346
3
3. Snowthrower frame
4. Keyhole slot
3
Figure 26
1. Engine PTO pulley
2. Snowthrower pulley
D. Replace the right side panel and close the
hood.
4. Remove the chute control rod by removing the
hairpin cotter connecting it to the universal joint
(Fig. 27). Slide the chute control rod out of the
end of the crank support.
4
Figure 27
1. Chute control rod
2. Crank support
5. Remove the crank support by removing the
hairpin cotter and clevis pin at its base (Fig. 28),
then lifting the support from its mounting post.
Installation
1
2
4
m–3696d
3. Belt
4. Spring–loaded pulley
1
2
3
m–4349
3. Universal joint
4. Hairpin cotter–medium
13