Assembling The Snowthrower - Toro 79366 Operator's Manual

Assembling the Snowthrower

Attach Lift Tube
Connect the lift tube to the snowthrower frame
assembly with the 2 5/8" (67 mm) clevis pin and
clip (Fig. 1)
3
1
4
Figure 1
1. Lift tube
2. Snowthrower frame
assembly
Assemble the Discharge Chute
Install the discharge chute assembly onto the
chute ring with (3) 5/16 x 3/4" (19 mm) carriage
bolts (heads to the inside), (3) 5/16" (8 mm)
washers and (3) 5/16" locknuts (Fig. 2).
1
4
3
Figure 2
1. Discharge chute assembly
2. Carriage bolt 5/16 x 3/4"
(19 mm)
2
m–3668d
3. Clevis pin 2 5/8" (67 mm)
4. Clevis clip
5
2
m–3719
3. Washer 5/16" (8 mm)
4. Locknut 5/16"
5. Chute ring
Verify the Drive Chain Tension
Verify that the drive chain has between 1/8" and 1/2"
deflection in the area shown in Figure 3. If the chain
is too tight or too loose, adjust it; refer to Adjusting
Drive Chain Tension, page 25.
2
1
Figure 3
1. Drive chain
Assemble Spring Tension Link
Insert the hooked end of the spring tension link
into the open hole in the outer leg of the spring
tension lever (Fig. 4).
1
2
Figure 4
1. Spring tension lever
2. Hooked end of spring
tension link
Installation
m–3795
2. Check deflection here
3
m–4087
3. Outer leg
5