C" Shaped Pin - Toro 79366 Operator's Manual

Installation
Figure 10
3. With the High–Low range selector in neutral
"N," pull the tractor forward toward the
snowthrower until the end of the snowthrower
frame is just underneath the tractor's front
Attach-A-Matic hitch (Fig. 11).
4. Ensure the latches on the tractor's front
Attach-A-Matic are open. Then slide the
pulley box completely into the Attach-A-Matic
hitch. Close the latches by rotating them down
(Fig. 11).
1
m–4344
Figure 11
1. Attach–A–Matic hitch
latches
5. Install (2) "C" shaped pins into the locking holes
of the pulley box. Secure them with (2) small
hairpin cotters on the inside (Fig. 12).
8
m–3446
2
2. Pulley box
3
Figure 12
1. Pulley box

2. "C" shaped pin

6. Now connect the snowthrower frame to the mid
Attach-A-Matic hitch. You will need the crank
support to help with this.
A. Continue pulling the tractor toward the
snowthrower until the snowthrower frame
connecting pins are directly below the mid
Attach–A–Matic
2
1
4
m–4345
3. Attach–A–Matic latch
4. Hairpin cotter–small
hitch (Fig. 13)