Removing The Snowthrower - Toro 79366 Operator's Manual

Installation
4
Figure 22
Left side of tractor shown
1. Support brace
2. Washer, 15/16" (24mm)
3. Hairpin cotter–large
15. Slide the crank support onto the mounting post
on the left–hand side of the tractor (Fig. 22).
Secure it in position with a locking pin and small
hairpin cotter (Fig. 23).
Figure 23
Left side of tractor shown
1. Crank support
2. Locking pin
12
1
3
2
m–3681
4. Mounting post for crank
support
1
2
3
m–4347
3. Hairpin cotter–small
16. Slide the chute control rod through the hole in
the end of the crank support and connect the end
of the chute control rod to the universal joint on
the snowthrower with a medium hairpin cotter
(Fig. 24).
4
Figure 24
1. Chute control rod
2. Crank support

Removing the Snowthrower

1. Park the tractor on a level surface, lower the
attachment lift, disengage the power take off
(PTO), set the parking brake and turn the
ignition key to "STOP" to stop the engine.
Remove the ignition key.
2. Relieve the snowthrower belt tension by pulling
the spring tension lever forward until you have
enough slack to disconnect the link from the
keyhole slot (Fig. 25).
1
2
3
m–4349
3. Universal joint
4. Hairpin cotter–medium