Washer 13/16" (21 Mm) - Toro 79366 Operator's Manual

Installation
6. Remove the support braces from the frame rods
protruding from the mid Attach-A-Matic
by removing the hairpin cotters and washers
(Fig. 28).
4
Figure 28
Left side of tractor shown
1. Support brace assembly
2. Washer, 15/16" (24mm)
3. Hairpin cotter–large
7. Remove the other ends of the two support braces
from the rear Attach-A-Matic
removing the hairpin cotters and washers
(Fig. 29).
8. Release the latches on the rear Attach-A-Matic
hitch and remove the support rod link (Fig. 29).
14
hitch
1
3
2
m–3681
4. Mounting post for crank
support
hitch mount by
1
3
5
6
7
Figure 29
1. Support rod link
2. Rear Attach–A–Matic
hitch
3. Front of tractor
4. Rear Attach–A–Matic
hitch latch
9. Disconnect the snowthrower lift rod from the
attachment lift plate by removing the clevis clip
and clevis pin (Fig. 30).
1
4
Figure 30
Right side of tractor shown
1. Middle hole in attachment
lift plate
2. Snowthrower lift rod
3. Clevis pin 1/2" x 1"
(25 mm)
10. Press the button of the mid Attach-A-Matic
hitch and carefully turn the lever clockwise to
release the snowthrower (Fig. 31). Please use
CAUTION during this step! The snowthrower
frame will drop to the ground.
4
2
m–3724
5. Support brace

6. Washer 13/16" (21 mm)

7. Hairpin cotter–large
5
3
2
2
m–3661
4. Clevis clip
5. Attachment lift plate