Clevis Pin 1/2" X 1" (25 Mm) - Toro 79366 Operator's Manual

Installation
7. Add (2) 1" (25 mm) washers onto the end of the
rod assembly, then slide it into the lift tube
(Fig. 16).
3
1
Figure 16
1. Rod assembly
2. Lift tube
Note: A washer may need to be removed
from the rod assembly for the holes to
line up with the attachment lift plate.
8. From beneath the tractor, connect the
snowthrower rod assembly to the middle hole in
the attachment lift plate (lift plate goes between
the rod assembly plates) with the 1" (25 mm)
clevis pin and clip (Fig. 17).
1
4
Figure 17
Right side of tractor shown
1. Middle hole in attachment
lift plate
2. Snowthrower rod
assembly
10
2
m–3450
3. Washers 1" (25 mm)
5
3
2
2
End view
m–3661
3. Clevis pin 1/2" x 1"
(25 mm)
4. Clevis clip
5. Attachment lift plate
9. Now install the snowthrower belt to the engine
PTO pulley:
A. Open the hood of the tractor
B. Remove the right–hand side panel.
POTENTIAL HAZARD
Components under the hood will be hot if
the tractor has been running.
WHAT CAN HAPPEN
Touching hot components can cause burns.
HOW TO AVOID THE HAZARD
Allow the tractor to cool before performing
maintenance or touching components
under the hood.
C. Route the snowthrower belt around the
engine PTO pulley (Fig. 18).
Note: Lifting up on the spring–loaded pulley
will ease installation of the belt.
3
Figure 18
1. Engine PTO pulley
2. Snowthrower pulley
10. Make certain that the wide side of the PTO drive
belt is toward the outside diameter of all (six)
pulleys (Fig. 19).
1
2
4
m–3696d
3. Belt
4. Spring –loaded pulley