Table of Contents
Advertisement
Install Discharge Chute (Fig. 5)
Models 38433 & 38438
1.
Set discharge chute onto chute ring. Align hole
in back of chute with center hole in ring and
install a carriage bolt and sems locknut. Position
nut on outside of chute.
Note:
Chute ring may be rotated to ease
assembly of discharge chute.
2.
Secure chute to remaining holes in chute ring
and tighten all nuts SECURELY.
Install Handle
1.
Remove tie securing control cable to lower
handle.
2.
Position upper handle so that control bar is on
top of handle, not underneath it.
3.
Models 38412 & 38418 – Secure upper handle
in place with (3) handle bolts, (1) eyebolt, and
(4) lock nuts. Use eyebolt to mount upper left
side of handle. Eyebolt must be positioned
perpendicular to handle when tightened (Fig. 6).
Models 38433 & 38438 – Secure upper handle
in place with (2) handle locks, (1) cable guide,
(2) curved washers and (2) knobs. Cable guide
must be perpendicular to handle with loop facing
out and up (Fig. 7).
Install Control Cable
Models 38412 & 38418
1.
Route control cable through eyebolt on left side
of snowthrower (Fig. 8).
2.
Hook spring to round hole at end of cable
adjuster (Fig. 9).
3.
Route cable through elongated hole in cable
adjuster. Insert Z fitting on end of cable into 3rd
hole on cable adjuster (Fig. 9).
4.
Slide spring cover over spring and cable adjuster.
Push spring end through hole at end of spring
cover (Fig. 8).
5.
Hook spring into top hole of control bar bracket
(Fig. 8).
6.
Move control bar back toward handle until slack
in cable is removed. The gap between the control
bar bracket and handle should be approximately
1/16"-1/8". See insert, Figure 8. If an adjustment
is required, refer to Adjusting Control Bar,
page 13.
Note:
The control cable must always have
slack in it when in the disengaged
position.
Install Control Cable
Models 38433 & 38438
1.
Route control cable through cable guide on left
side of snowthrower (Fig. 10).
2.
Hook upper end of control cable in rear hole
(hole with arrow) in control bar bracket
(Fig. 10).
3.
Move control bar back toward handle until slack
in cable is removed. The gap between bottom of
handle and stop on control bar (left hand side on
bottom of handle) should be approximately
1/16"-1/8". See insert, Figure 10. If an
adjustment is required, refer to Adjusting
Control Bar, page 13.
Note:
The control cable must always have
slack in it when in the disengaged
position.
9
Hide quick links:
Advertisement
Table of Contents
