Table of Contents
Advertisement
Installing the Discharge Chute
Install the deflector shield and the discharge chute
assembly onto the snowthrower housing with three
carriage bolts (heads to inside), washers, and lock nuts
(Fig. 2).
2
1
5
Figure 2
1. Discharge chute
2. Carriage bolt
3. Washer
Installing the Cable Guide
1. If your traction unit has a bolt installed in the
underside of the loader arm cross bar, between the
right loader arm and the hydraulic hoses, remove the
bolt.
2. Place the cable guide over the loader arm cross bar on
the far right side (Fig. 3).
3. Insert the clamp into the slot in the cable guide, then
secure it with a knob (Fig. 3).
1
5
Figure 3
1. Cable guide
2. Loader arm cross bar
3. Clamp
Installing the Snowthrower on
the Traction Unit
1. Connect the snowthrower to the traction unit mount
plate and connect the hydraulic lines. Refer to your
traction unit operator's manual for instructions.
3
4
m–4543
4. Lock nut
5. Deflector shield
2
4
3
m–4545
4. Slot
5. Knob
2. Locate the hole in the side plate of the frame (Fig. 4)
that is located just behind and to the left of the left
handle. If there is no hole, complete the following:
A. Copy page 8, cut out the template, and align it
with the upper left side plate of the traction unit
(the arrow on the template should point up).
Note: The template is designed to fit on the outside of the
side plate.
B. Mark the hole location on the side plate at the
center of the cross hairs on the template.
C. Drill a 3/8 to 1/2 inch (1 to 1.25 cm) hole through
the frame at the marked location.
3. Place the chute control bracket between the left handle
and the side plate (Fig. 4).
4. Secure the bracket to the frame with a knob and the
large washer (Fig. 4).
5. Insert the handle clamp into the slot in the chute
control bracket, wrapping it around the handle, then
secure it with a knob (Fig. 4).
1. Chute control bracket
2. Upper left side plate
3. Knob
6. Route the chute control cable through the cable guide.
Removing the Snowthrower
from the Traction Unit
1. Start the engine and lower the attachment to the
ground or onto a trailer, then stop the engine.
2. Remove the knobs, washer, and handle clamp from the
chute control bracket and remove the bracket.
3. Install the handle clamp, washer, and knobs on the
chute control bracket for safe keeping.
4. Remove the chute control cable from the cable guide.
5. Disconnect the hydraulic lines and remove the
snowthrower from the mount plate. Refer to your
traction unit operator's manual for instructions.
7
Figure 4
4. Left handle
5. Large washer
6. Handle clamp
m–4158
Advertisement
Table of Contents
