Fujitsu SH-E514TR1 10 User Manual page 64

Interval: Enter the interval value used here. This value must be between 5 and 600 seconds. By default, this value is
5 seconds.
Retries: Enter the retries value used here. This value must be between 0 and 360. By default, this value is 3. Tick the
Infinite option to disable this feature.
From Port / To Port: Select the appropriate port range used for the configuration here.
Type: Select the type of storm attack that will be controlled here. Options to choose from are Broadcast, Multicast,
and Unicast. When the action is configured as the shutdown mode, the unicast refers to both known and unknown
unicast packets; that is, if the known and unknown unicast packets hit the specified threshold, the port will be
shutdown.
Action: Select the action that will be taken here. Options to choose from are None, Shutdown, and Drop.
None - Do not to filter the storm packets.
Shutdown - Shut down the port when the value specified for rise threshold is reached.
Drop - Discard packets that exceed the risen threshold.
Level Type: Select the level type option here. Options to choose from are PPS and Kbps.
PPS Rise: This is available when PPS is selected in Level Type. Enter the rise packets per second value here. This
option specifies the rise threshold value in packets count per second. This value must be between 0 and 14881000
packets per second. If the low PPS value is not specified, the default value is 80% of the specified risen PPS.
PPS Low: This is available when PPS is selected in Level Type. Enter the low packets per second value here. This
option specifies the low threshold value in packets count per second. This value must be between 0 and 14881000
packets per second. If the low PPS value is not specified, the default value is 80% of the specified risen PPS.
Click Apply to accept the changes made for each individual section.
After selecting the Kbps option as the Level Type, the following parameters are available.
The fields that can be configured are described below:
KBPS Rise: Enter the rise KBPS value used here. This option specifies the rise threshold value as a rate of kilobits
per second at which traffic is received on the port. This value must be between 0 and 2147483647 Kbps.
KBPS Low: Enter the low KBPS value used here. This option specifies the low threshold value as a rate of kilobits per
second at which traffic is received on the port. This value must be between 0 and 2147483647 Kbps. If the low KBPS
is not specified, the default value is 80% of the specified risen KBPS.
Click Apply to accept the changes made.
SH-E514TR1 10 Gigabit Ethernet SmartPro Switch User Manual
Figure 12-6 Storm Control (Kbps)
59