Firmware Upgrade From Http; Firmware Upgrade From Tftp; Firmware Backup To Http - Fujitsu SH-E514TR1 10 User Manual

Firmware Upgrade from HTTP

This window is used to upgrade the firmware from HTTP.
The fields that can be configured are described below:
Source File: Click Browse to browse your inventories for a saved firmware file.
Destination File: Enter the destination filename and path where the new firmware should be stored on the Switch.
This field can be up to 32 characters long.
Click Upgrade after selecting the firmware file you want to restore.

Firmware Upgrade from TFTP

This window is used to upgrade the firmware from TFTP.
The fields that can be configured are described below:
TFTP Server IP: Upgrade the firmware from a remote TFTP server. Specify the TFTP server IP address.
Source File: Enter the source filename and path of the firmware file located on the TFTP server here. This field can
be up to 32 characters long.
Destination File: Enter the destination filename and path where the new firmware should be stored on the Switch.
This field can be up to 32 characters long.
Click Upgrade after selecting the firmware file you want to restore.

Firmware Backup to HTTP

This window is used to back up the firmware to HTTP.
The fields that can be configured are described below:
Source File: Enter the source filename and path of the firmware file located on the Switch here. This field can be up
to 32 characters long.
SH-E514TR1 10 Gigabit Ethernet SmartPro Switch User Manual
Figure 5-5 Firmware Upgrade from HTTP
Figure 5-6 Firmware Upgrade from TFTP
CAUTION: Do not disconnect the PC or remove
the power cord from the Switch until the upgrade
completes. The Switch may crash if the firmware
upgrade is incomplete.
Figure 5-7 Firmware Backup to HTTP
9