Upgrading The Projector Software - Barco SIM 7C R9011206 Service Manual

5. Projector software (firmware)
5.3

Upgrading the projector software

C
AUTION
be done twice: once for the master PMP, once for the slave PMP.
Upgrade tool
The name of the upgrade tool is according to this format:
SIM7v00.37.0045.exe
device
Image 5-3
Upgrade tool
Two main parts can be seen:
• device: this is the projector type
• version: indicates the version
- two first digits (e.g. 00): major revision
- second pair of digits (e.g. 10): minor revision
- last four digits (e.g. 0001): build number
Necessary tools
• local network with DNS and DHCP server
• latest projector software version (= upgrade tool)
How to upgrade the projector?
1. Download the latest projector software version from the PartnerZone or from the Barco Intranet (InfoBarco)
2. Save this upgrade file on a computer which can be connected to the same (local) network as the projector
3. Make sure that the projector is switched off
4. Connect this computer to the local network in which the projector is included
Note: Both ethernet connectors of the projector must be connected to this local network, which must include a DNS and a
DHCP server!
5. Switch on the projector
6. Double click the upgrade tool
7. Enter the IP address or host name of the considered PMP and hit OK
Image 5-4
Upgrading the projector (1)
Note: The host name of the master PMP is S139xxxxxxa, where 139xxxxxx is the serial number of the projector.
Note: The host name of the slave PMP is S139xxxxxxb, where 139xxxxxx is the serial number of the projector.
8. Compare the version of the downloaded upgrade tool to the actual installed version
22
:
Both PMPs must be upgraded in this projector. This implicates that the following procedure must
version
R59770119 SIM 7C 28/05/2008