General Information; Servicing The Sim 7C; Conventions; General Instructions - Barco SIM 7C R9011206 Service Manual

3. GENERAL INFORMATION

3.1

Servicing the SIM 7C

Important remark about servicing the SIM 7C
If a SIM 7C projector fails, it will not be repaired on site, but it will be replaced by a good projector.
This is why this service manual only contains procedures to replace lamps and dust filters.
How to take the projector out of the system is described in the System manual.
3.2

Conventions

Projector orientation
In this manual, references to location (left, right, front, rear, top, bottom) on the projector are made as shown in the following image.
rear right
Image 3-1
Projector orientation convention
3.3

General instructions

Overview
•

Connector instructions

• Wires and cable ties
• EMC shielding clamps
3.3.1 Connector instructions
C
AUTION
Do not use any kind of tools when unplugging a connector.
C
AUTION
unlocking if applicable).
Overview of the connectors
Several types of connectors are used in the projector (ordered by size):
R59770119 SIM 7C 28/05/2008
top
front
bottom
:
Always respect the ES (electrostatic sensitivity) instructions.
:
Never pull the wires to unplug a connector. Always grip the connector and pull to unplug (after
left
3. General information
9