Installation Main Menu - Barco F50 User Manual

5.7 Installation main menu

User Manual - Introduction F50 User Manual - Overview
Downloaded From projector-manual.com Barco Manuals
image orientation :
Rotate the image on the imaging device in desktop front, desktop rear, ceiling
front, ceiling rear.
source scan : Search through all input connectors for an active signal or stay on one connector.
IR front Enable or disable front IR-receiver.
IR rear Enable or disable rear IR-reciever.
OSD enable : Sets how the OSD messages should appear.
On: All OSD messages are shown.
Only warnings: Only critical OSD messages are shown.
Off: No OSD messages are shown. The OSD menu is still accessible by clicking
menu on either the remote or the keypad.
test image: Displays internal test images for projector alignment and setup. Option to show
4:3, 16:9, 16:10, 1.85:1, 2.35:1, 5:4, combined, off
4:3: fills the imaging device with a white image, but marks out the 4:3 area in the
center of the image.
16:9: fills the imaging device with a white image, but marks out the 16:9 area in
the center of the image.
16:10: fills the imaging device with a white image, but marks out the 16:10 area
in the center of the image.
1.85:1: fills the imaging device with a white image, but marks out the 1.85:1 area
in the center of the image.
2.35:1: fills the imaging device with a white image, but marks out the 2.35:1 area
in the center of the image.
5:4: fills the imaging device with a white image, but marks out the 5:4 area in the
center of the image.
Combined: fills the imaging device with a white image and marks out the all of
the above aspect ratios.
sync termination VGA :
sync termination SYNC1 : Enable sync termination to 75 Ω /2.2 kΩ
sync termination SYNC2 : Enable sync termination to 75 Ω /2.2 kΩ
sync termination SYNC3 : Enable sync termination to 75 Ω /2.2 kΩ
DisplayPort 1 eq Choice between Normal and High
DisplayPort 2 eq Choice between Normal and High
EDID : Sub menu for EDID.
synchronization: Sub menu for synchronization.
Enable sync termination to 75 Ω /2.2 kΩ
(enables receiving signals via longer cables/with a higher bit rate)
(enables receiving signals via longer cables/with a higher bit rate)
36