Different Mounting Configurations Of The 1812 Access Plus Models - DKS 1812 Access Plus Installation & Owner's Manual

Different Mounting Configurations of the 1812 Access Plus Models

Surface and Wall mount models can be mounted directly to a wall, pilaster or post mounted using a DoorKing mounting post
(there are several different styles available). The flush mount model is designed to be mounted into a pilaster, wall or kiosk. In
any case, be sure it is securely mounted and is not subject to continuous vibration from closing doors or gates.
Mount on a Mounting Post
Use existing 4 holes in cabinet box to
bolt the surface or wall mount models
on a DoorKing mounting post. Use
the hardware that is supplied with the
mounting post.
1812-162-V-5-16
Note: A gooseneck mounting
post anchored in concrete
does not make a good ground.
Mount Directly to a Wall or Pilaster
Use the 4 existing holes in the
cabinet box. Run conduit inside or
outside of wall or pilaster if desired.
Use appropriate hardware to mount
the cabinet (Not supplied). Be sure
that the mounting hardware does not
protrude into the cabinet where it
could cause a short.
Plastic screw anchors for
masonry if required.
(Not supplied)
C o
n d
u i t
( S h
o w
n i n
s i d
e w
a l l )
IMPORTANT Choose
how your 1812 will
function (Telephone
Mode or Intercom
Mode) on pages 14
thru 18 and run the
indicated wires to the
cabinet. Also route
RS-485 and/or network
connection wires to the
cabinet if they are to be
used. Run ALL wires
that will be needed
during the cabinet
installation.
9