Repeater Bridging Setup Guide - Auto Mode - LevelOne WAB-2000 User Manual

WAB–2000 Wireless Access Point
As stated previously, complete any other setup screens following gen-
eral instructions in Chapter 3.
Repeater Bridge Configuration
A repeater setup can be used to extend the wireless signal from one
bridge connected to an Ethernet LAN wirelessly so that another bridge
can control a wireless LAN at a distance.
�������
���
������
Repeater Bridging Setup Guide - Manual Mode
Direction
Wireless Bridge — General (Manual BridgingMode)
Wireless Mode
Tx Rate
Channel
Tx Power Mode
Propagation Dis-
tance
Bridging Mode
Signal Strength
LED MAC
Spanning Tree
Protocol
BSSID
Wireless Bridge — Encyption
Wireless Configu-
ration – Bridging
Encryption
29000156-001 A
���
������
�������
������ �
������ �
�������
��������
Bridge 1 Bridge 2
802.11a 802.11a
AUTO AUTO
Same as Bridge 2 Same as Bridge 1
Auto Auto
< 5 Miles < 5 Miles
manual manual
Not Assigned Not Assigned (select
(select from drop- from drop-down
down list) list)
Enable (or Disable Enable (or Disable
if no bridging loop if no bridging loop
possible) possible)
Add Bridge 2's Add Bridge 1's and
MAC Bridge 3's MAC
Select appropriate Select appropriate
key type/length key type/length
and enter key and enter key value.
value. Must be the Must be the same as
same as that on the that on the other 2
other 2 Bridges. Bridges.
Chapter 4: Wireless Bridge Configuration
�������
������ �
�������
��������
Bridge 3
802.11a
AUTO
Same as Bridge 1
Auto
< 5 Miles
manual
Not Assigned (select
from drop-down
list)
Enable (or Disable
if no bridging loop
possible)
Add Bridge 2's MAC
Select appropriate
key type/length
and enter key value.
Must be the same as
that on the other 2
Bridges.
���
������
67