Table of Contents
Advertisement
ENGLISH
Before commencing the cutting operation ensure that the latch is fully secured:
partial closure may damage the tool head.
2.2) Blade advancement
Operate moveable handle (44) for lower blade advancement. This first stage rapidly
closes the lower blade to the conductor. Make sure that blades (18 and 23) are exactly
positioned on desired cutting point, otherwise re-open blades following instructions as §
2.4 and re-position the cable.
2.3) Cutting
Continue operating the moveable handle, the lower blade advances gradually until the
cable is fully cut.
T
he Tool is designed for cuTTing copper
!
▲
.
forced cables
do noT aTTempT To cuT guy wire and ground rod
2.4) Blade opening
Press the pressure release lever (58) for the rapid retraction of the ram and subsequent
blade (18) opening.
2.5) Rest setting
After completion of the work, press the release lever (58) to release the oil pressure (ref.
§ 2.4).
3. WARNING
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance
of the tool:
3.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove
any residual, especially close to pin and moveable parts.
3.2) Storage
When not in use, the tool should
be stored and transported in
the canvas bag, to prevent
damage.
Canvas bag: ref. 010; size
545 x 160 mm (21.4 x 6.3 in.);
weight 0,15 kg (0.3 lbs).
,
aluminium and aluminium sTeel rein
.
CANVAS BAG
3
03
44
13
FIG. 2 TOOL POSITION FOR MAINTENANCE OPERATIONS
POSITION DE L'OUTIL POUR L'ENTRETIEN
WERKZEUG WARTUNGSPOSITION
COLOCACION PARA LAS OPERACIONES DE MANTENIMIENTO
POSIZIONAMENTO PER LE OPERAZIONI DI MANUTENZIONE
28
01
02
58
12
14
18
Advertisement
Table of Contents
