Removing And Installing A Processor - Clevo W150HRM Service Manual

Removing and Installing a Processor

Processor Removal Procedure
1. Turn off the computer, remove the battery
2. The CPU heat sink will be visible at point
, ,
3. Remove screws ,
6 5 4
size of the screwdriver is below 4mm. when removing or tighting screw
degree angle from the mainboard.(Figure
a.
A
c.
(page 2 - 5) and the component bay cover
(Figure 6a) on the mainboard.
A
, and
, the reverse order indicated on the label. *Note: Make sure that the
3 2 1
6c)
b.
1
3
5
(page 2 - 9).
, and its position should be at a 90
5
5
6
4
2
Removing and Installing a Processor 2 - 11
Disassembly
Figure 7
Processor Removal
a. Remove the cover and
Iocate the heat sink.
b. Remove the screws in
the order indicated.

• 6 Screws