Din-Rail Mounting Installation - Korenix 5804 User Manual

Programming returns:
getdo Return DO status string. (2 DO)
Ex: "1:0\n\r". (delimiter is ":", order is "DO_1:DO_2", "\n\r" is end flag.)
getdi Return DI status string. (4 DI)
Ex: "1:0:1:0\n\r". (delimiter is ":", order is "DI_1: DI_2:DI_3:DI_4", "\n\r" is end flag.)
setdo Return "OK" when success. Return error message when failure (like: "Unknown command, No
DO status given").
And end flag is "\n\r".

2.9 DIN-Rail Mounting Installation

The DIN-Rail clip is already attached to the JetPort 5804 Series products when packaged. If the DIN-Rail
clip is not screwed on the JetPort, follow the instructions and the figure below to attach the DIN-Rail clip to
the JetPort.
1. Use the screws to attach the DIN-Rail clip to the rear panel of the JetPort 5804/5804i.
To remove the DIN-Rail clip, reverse step 1.
Follow the steps below to mount the JetPort to the DIN-Rail track.
1. First, insert the upper end of the DIN-Rail clip into the back of the DIN-Rail track from its upper side.
(Note: Here we use JetNet Industrial Ethernet Switch as an example.)
2. Lightly push the bottom of the DIN-Rail clip into the track.
JetPort 5804 Wireless Serial Device Server User's Manual
18