Troubleshooting - York Fitness t501 Owner's Manual

troubleshooting

!
If you have a problem with your treadmill, before you do anything else please check that all the cables have
been connected correctly. Loose cables are very common and many problems can be solved by making
The table below details the most common problems and how to fix them. If you still have a problem after going through the troubleshooting
guide please call your local York distributor for advice.
Problem
Treadmill will not start
Running mat slipping
Treadmill noisy
Inaccurate pulse rate
Malfunctions and Errors
The console will display information regarding operational faults
with the treadmill. If your treadmill behaves in an unusual way and
seems to have developed a fault, turn it off at the electrical outlet
and then back on again. This should clear the treadmill of incidental
errors and prepare it for normal operation. If there is still a problem
call your local York distributor for advice. Please find below some
specific error messages you may see on the display:
•
E1 - Communication error
•
E2 – Motor connection error
•
E3 - Speed sensor error
•
E4 – Relay error
•
E7 - Safety key error
In both cases turn the treadmill off at the electrical outlet and then
back on again. If this doesn't work, call your local York distributor for
advice.
16
sure the cables are properly connected
Cause
1. Not plugged in.
2. Safety key not on correctly.
3. Treadmill circuit breaker.
4. Switched o .
5. Loose connection.
1. Running mat loose.
2. Deck needs lubrication.
1. Loose hardware.
2. Motor straining.
3. Clicking sound - roller knocking.
1. To much hand movement.
2. Palms too wet.
3. Gripping hand grips too tight.
4. Wearing rings.
1. Plug into suitable outlet.
2. Insert safety key.
3. Reset circuit breaker.
4. Turn the switch on.
5. Un-plug and re-plug electrical cord.
1. Tighten running mat.
2. Lubricate mat and deck.
1. Tighten all visible screws, nut, and bolts.
2. Check mat tension - 3 nger test.
3. Adjust rear rollers - check the tension.
1. Stand on side rails to get accurate pulse reading.
2. Dry palms.
3. Grip using moderate pressure.
4. Remove all rings.
In the event of an electrical failure the treadmill will automatically
shut off. To restart the treadmill:
1. Unplug the power cable from the treadmill
2. Push in the safety switch
3. Re-plug the power cable into the treadmill
Correction