Table of Contents
Advertisement
11.3. Downloading
•
When you receive a new release verify the files as mentioned previously in
Release
. For changing the file names refer to the same section.
•
Choose one of three options:
1. Run the tftp server in the PC where firmware files are available.
2. Keep the firmware files in the same directory as the tftp server running directory.
3. Set the firmware directory path in the tftp server.
•
If your server is configurable, make sure that the download block size is set to 512
bytes and port numbers are set to the default tftp port.
•
Configure the DPH80 systems as above, and verify with the example configuration
shown above.
•
Dial the firmware download key in DPH80. (The factory default value is 456*#.)
•
When the download starts, you will see the progress in the tftp server.
•
After the tftp download is completed, verify the new firmware version by logging in to
DPH80.
If the firmware version does not match, then verify the above procedure has been
followed, and try it again.
64
Section 2.
Advertisement
Table of Contents
Troubleshooting
