Configuration Main Page; General Configuration - D-Link DPH-80 User Manual

Hide thumbs Also See for DPH-80:

Table of Contents

Password: is case-insensitive with a maximum of 20 characters.

After logging in, the D-Link DPH-80 Phone Configuration page is displayed and this

page provides links to other pages.

10.3. Configuration Main Page

Click on General Configuration. A new page containing information about your system

and the DPH-80 will appear.

Firmware Version : It shows the current firmware version of the IP phone. It is updated

whenever the SIP phone software is updated. It cannot be modified.

Hardware Version: It shows the current hardware version of the IP phone. It cannot be

modified.

MAC Address: This shows the MAC address of the board in colon-separated hex form.

If it contains the default value ff:ff:ff:ff:ff:ff, it can be modified once to a non-default

Once modified, it will be grayed out and cannot be changed again.

value.

Country Code: This is a drop-down menu. Select the appropriate country. This field

controls the type of tones played by the SIP phone.

static

Obtain IP address using: If

option is selected, then a user-configured IP address,

Net Mask, Default gateway, and DNS server address would be used for the phone. If

DHCP

is selected, then these values will be obtained using DHCP. If the PPPoE is

selected, and using the PPP username and password for authentication, PPPoE obtains

an IP address for the phone. Default selection is Static-enabled.

PPP user name:

This is the user name used for PPP authentication with the PPP server

while obtaining an IP address via PPPoE.

Table of Contents