Optibase MGW 2400 WMT User Manual page 66

Chapter 3 • Accessing MGW 2400
56
3. From the Privileges list, choose the desired user profile.
4. Enter the user name and password for the desired user and
click OK
appears with the Modules page open. The IP address of the
unit appears in the Status bar to the left and the current user
level to the right.
•
For required passwords, refer to page 104.
•
The blue arrow to the upper right
green LED in the Status bar indicate that MGW 2400
is responding properly.
Logging on to a different Unit or as a different User
If the arrow is broken and turned red
Re-Login. In this case, first close MGW 2400 EMS and then
log on to a different unit.
1. On MGW 2400 EMS's toolbar, click Re-Login
the Login window appears.
2. In the Device IP/Name field, enter the relevant MGW 2400
unit's IP address.
•
To log on to the same unit as a different user, leave
the IP address as is and choose the desired user from
the Privileges list.
3. Refer to the previous page for further information and
instructions.
If you try to log on as Administrator or Super User and there is
already an Administrator or Super User logged on, MGW 2400 logs
you on as Guest.
; the MGW 2400 EMS Main window
Note
and the
; you cannot use
;