Table of Contents
Advertisement
Chapter 2 • Getting Started
18
To connect a video source
•
Composite Video. Use the Video BNC cable (catalog
number BZA3636) as illustrated in Figure 5 to connect a
Composite video source to the COMP.VID connector.
Figure 5: The Video BNC Cable (BZA3636)
•
S-Video. Use the S-Video MiniDIN cable (catalog number
WCA2210) as illustrated in Figure 6 to connect an S-Video
source to the S-Video connector.
Figure 6: The S-Video MiniDIN Cable (WCA2210)
•
Digital Video. Use the Low Loss Digital Video Belden
1694A cable (catalog number WCA5971) to connect a
digital video source to the SDI connector. This connector
ships with MGE-400D encoding modules only.
•
MGE 400D encoding modules support the SMPTE 125M-1995 SDI
standard. Other SDI standards will cause the video frames to be shifted
10 lines down. I.e. the content of the top 10 video lines is unknown and
the 10 bottom lines will not be encoded.
•
MGW 2400 does not support SECAM sources.
Note
Advertisement
Table of Contents
