Table of Contents
Advertisement
To set communication parameters in HyperTerminal:
1.
Open HyperTerminal and click Properties
HyperTerminal's toolbar. The Properties screen appears.
2.
From the Connect using list, choose COM1 to which you
will connect MGW 2400 and click Configure. The COM
Properties screen appears.
Figure 9: HyperTerminal's COM Properties Screen
3.
Enter the parameters into the respective fields as shown in
Figure 9.
4.
Click OK; HyperTerminal is now ready to communicate
with MGW 2400.
Chapter 2 • Initial Configuration
in
21
Advertisement
Table of Contents
