The Problem
Possible Cause
•
I connected a
You may have
SCSI hard
chosen a
disk to MGW,
forbidden SCSI
but MGW
address.
2400 won't
boot.
I can't encode
•
Bad source or no
a stream, the
source connected
Source LED is
off and the
Channel LED
is green.
•
The Channel
Channel error
LED is red
•
The Channel
Software error
LED blinks
red
Chapter 5 • Troubleshooting
Possible Solution
•
Check the SCSI address.
Note that '7' is reserved for
the SCSI controller inside
MGW 2400.
•
Connect the source properly.
•
Restart encoding using
different parameters. If this
does not help, refer to the
Error Message list in the
MGW 2400 EMS help file.
•
If this error persists, call for
technical support.
107