Table of Contents
Advertisement
To edit the default IP address at a later stage:
1.
Make sure that you close the MGW 2400 EMS.
2.
Browse the MGW 2400 EMS folders for EMSConfig.ini
and create a backup. Save the backup in a different folder
on your PC.
3.
Open EMSConfi.ini; the first line reads for example
ems2400.snmp.deviceIP 172.16.100.137.
4.
Change the registered IP address to the desired IP address.
5.
Save and close EMSConfig.ini; the MGW 2400 EMS
displays the new IP address once the MGW 2400 EMS
Logon window appears.
•
Make sure that only one NIC is enabled on the Management PC,
otherwise the MGW 2400 EMS cannot communicate properly with MGW
2400.
•
To install a new version of MGW 2400 EMS at a later stage, first
uninstall the current version of MGW 2400 EMS.
•
If the available disk space is insufficient, installing MGW 2400 EMS will
fail.
•
If you want to uninstall the MGW 2400 EMS after you edited
EMSConfig.ini, you will have to manually delete the MGW 2400 folder.
Chapter 3 • Installing Software
Note
51
Advertisement
Table of Contents
