Table of Contents
Advertisement
3.
Slide a plastic bushing, flanged end last, into the
hinge area on the door.
4.
Insert a hinge
pin into each hinge bushing, flat
side
out.
5.
Place the plastic door seal into position on the
deck making sure that the groove for the door
cable faces the back of the door.
6.
Place the door assembly into position on top of
the door seal and the housing. Secure with the
hinge clamps and socket head capscrews, one
set per side. Check to make sure that the door
operates freely.
7.
Slip the door cable through the hole
in the top of
the door and slip the spring on, making sure that
the J hook on the bottom faces the right side of
the mower.
8.
9.
10.
11.
Tip the mower on
its
side and pull the bottom of
the spring into position using a
thin rope or
insulated electrical wire. See Figure
130.
Check for proper operation
of the spring by
watching from the bottom of the unit while
opening and closing the door.
Install the black plastic transmission cover.
NOTE:
It
may be necessary to rotate the
transmission back slightly to provide clearance.
Make sure that the belt slips into
the grooves on
the transmission cover.
Fasten the screen panel to the housing using the
two flanged head self-tapping screws. Make sure
that the top edge
of the screen panel fits
underneath the lip at the top of the housing.
Vacu-Power
Mower
73
Grass
Bag and Discharge
Door
Advertisement
Table of Contents
