Table of Contents
Advertisement
10.
Before installing the right control housing, check
to make sure that both cable sheath ends are
fully seated in their slots in the left housing. Also
make sure that the sleeve passes through all
components including the left control housing.
Finally, make sure that the roll pin passes
through the rocker arm and control bar.
Install the right control housing and secure
with
the 2 nylon locknuts.
11, Install the 3 flanged head screws that retain the
two control box halves.
12. Check for
proper operation of the entire BBC
system. Correct as required.
13. Bend the throttle control locking tab forward to
provide positive lock with the throttle control and
install the throttle control.
14.
Adjust the BBC cable as described under BBC
Adjusting the Blade Brake, page 26.
15.
Adjust the traction cable if you are working on a
self-propel model as described under Drive
Control Cable Adjustment, page 37.
BBC BELLCRANK SYSTEM
BBC Bellcrank System Operation
The bellcrank system shown
in Figure
86, performs two
important functions. It changes
the direction of control
input and also regulates the force applied
to the blade
brake assembly.
Vacu-Power
Mower
51
The directional change is accomplished by means of
a
bellcrank. The bellcrank rides
on a nylon bushing and
is attached to the cable support bracket.
Regulation of the force applied to the brake plate
assembly is accomplished by means
of the
"over-tension' spring. The control link, which provides
the actual input to the brake plate assembly, is not
attached directly to the bellcrank,
but
rather through a
compression spring. This spring insures that the sam
force is applied to the blade brake assembly each time
the blade is engaged. It also helps reduce shock lo
Figure
86
NOTE: This spring is the primary indicator
of
proper
BBC adjustment.
It
should measure 25.4k1.5 mm
(1
1/16")
with the blade engaged, when properly
adjusted.
If
spring measures more than
32
mm
(1-1/4"), correct by moving the jam nuts on the turn
buckle arrangement midway up the control cable.
BBC Bellcrank System Disassembly
1.
Remove the flanged head self-tapping
capscrews securing the upper BBC cover
to the
housing and remove the upper BBC cover.
2.
Pull the black plastic transmission cover
up to
remove
it
from the housing. See Figure
87.
3.
Remove the shoulder bolt and flanged nut
securing the bellcrank to the control cable
bracket. Once loose, remove the bellcrank
assembly complete with control link and remove
from the unit. See Figure 88.
4.
Remove the bushing from inside the bellcrank.
BBC System
Advertisement
Table of Contents
