Table of Contents
Advertisement
Pivoting Zone Start Brake System Assembly
(cont'd)
Figure 107
4.
Slip the compression spring over the cable, then
slip the lugged end of the cable into the slot in
the brake plate. Slip
the spring between the
brake plate and mounting plate, then secure with
the cable clamp and ground strap stop
as shown
in Figure 108.
Figure 108
5.
Adjust the cable
as
described below.
Pivoting Zone Start Brake System Adjustment
The cable is not adjustable at the brake. See Zone Start
Brake Adjusting the Blade Brake, page 25 for cable
adjustment information.
Advertisement
Table of Contents
