Toro VACU-POWER Service Manual page 73

Handle Assembly lnstallatlon (cont'd)
3 .
Bring the handle up into position and secure with
the handle latches.
NOTE: The handle latches should be on the
inside of the handle. For convenience, adjust to
the center hole on the handle latches.
4.
Install the control panel into position at the top of
the handle and secure with four self-tapping
screws.
5.
Lift the control bar and safety control mechanism
into position at the top of the handle. Secure the
right side of the control bar with the handle screw,
the support spacer and the locknut.
6.
BBC Models:
With the BBC control box in its proper position
and the temporary fasteners still installed
through the control box, force the two left hand
handle screws through the handle in the BBC
control box. This will force out the temporary
fasteners and will insure that no BBC control
box components come loose. Secure the
larger handle screw with a washer and nylon
locknut and the smaller handle screw with just
a locknut.
Handle Assembly
7.
Zone Start Units:
Bring the control bar assembly into position at
the top of the handle and insert the handle
screws through either side of the handle.
Secure with the nylon locknuts. Make sure the
brake cable and the traction cable are properly
positioned in the short block, then,
i f
necessary, reinsert them into the traction lever
and the control lever on the control bar. Before
tightening the cable support bracket, adjust
the brake and traction cable as described in
the Maintenance Section.
Secure the cables to the handle with cable ties
in the locations shown in Figure
122.
- ~ ~
~ _ _ I
Figure
122