Toro VACU-POWER Service Manual page 57

BBC Bellcrank System Disassembly (cont'd)
Figure 87
Figure 88
5.
Using the control link to hold the control pin,
remove the flanged head screw from the control
pin.
CAUTION ! Always wear safety goggles and
gloves when disassembling items under
spring tension or compression.
6.
Remove the control link from the control pin.
7.
Inspect all parts for wear and damage and
replace as necessary.
BBC Bellcrank System Assembly
1. Insert the control pin into the recessed area on
the bellcrank.
2.
Place the spring onto the control pin. Place the
spring retainer onto the spring and insert the
screw into the control pin. Using the control link
to prevent rotation of the control pin, tighten the
flanged head screw until the retainer bottoms out
on the control pin. See Figure 89.
BBC
52
Figure 89
4.
Note the orientation of the control link in Figure
90. Make sure that
it
is installed correctly into the
bellcrank.
Figure 90
5.
Slide a flat washer and a bushing onto the
carriage bolt and slide into the front side of the
bellcrank as shown in the figure above. Complete
reassembly of the bellcrank system by sliding
another flat washer onto the carriage bolt.
NOTE: Lubrication of the bushing is not rec-
ommended.
6.
Hook the end of the control link into the brake
plate lever, then slip the BBC control cable onto
the bellcrank. Finally, slip the carriage bolt
through the hole in the control cable bracket and
secure with the flanged nut.
NOTE: The serations
in the flanged nut must fully
seat on the control cable bracket.
Vacu-Power Mower