Toro VACU-POWER Service Manual page 41

Table of Contents

Advertisement

Gear Selection Control Adjustment (cont'd)
5.
Reinstall access cover
by pressing from the
outside.
6.
Test to insure proper operation.
TRACTION CONTROL
Traction Control Operation
A belt transfers power from the engine
to the
transmission. The tension
on this belt determines
whether the unit will drive or not. Tensioning is
accomplished by tilting the transmission rearward.
The operator controls this by means
of the black
control bar at the top of the handle. When the operator
brings the control bar up to the handle, a cable is
tightened and causes the transmission to rock
backwards. When the operator releases the control
bar, the transmission is allowed to
tilt
forward which
loosens the belt. A belt guide at the engine and another
on top of the transmission insure that the belt
adequately releases the pulleys. This provides positive
control.
Adjustment of the control bar is accomplished by
means of
a
jam and locknuts arrangement on the
traction cable on '88 and '89 units. '90 and newer units
use a fingertip adjustment near the control
bar.
Traction Control Cable Removal
1.
Disconnect the spark plug lead from the spark
plug to prevent accidental starting.
2.
Remove the two flanged
head self-tapping
screws securing the screen panel to the housing
and remove the screen panel. See Figure
47.
Figure 47
Self-Propel System
3 .
Remove the black plastic transmission cover
from the tranmission area by pulling straight up
and
out.
4.
Squeeze the 'ears' at the end of the cable sheath
and pull the cable out vertically. See Figure 48.
Figure 48
5.
Tip the unit on its side and remove the end of the
cable from the tranmission belt guide.
6.
Stand the unit upright then bend the control
panel tab out of the way. Drive the throttle control
o u t
of the left-hand side of the control panel with
a rubber mallet.
7.
Put a piece of tape on the outside of the left
handle to keep the two special carriage bolts in
place when working on the BBC control box.
8.
Remove the three self-tapping screws from the
right side of the BBC control box cover. See
Figure 49.
36
Figure
49
Vacu-Power Mower

Advertisement

Table of Contents
loading

Table of Contents