Table of Contents
Advertisement
BBC Control Box Disassembly (cont'd)
8.
Remove the rocker
arm as an
assembly,
complete with cable lever and control hook.
9.
Remove the cable lever from
the rocker arm
assembly.
the control hook and torsion spring.
10.
Press the roll pin from the rocker arm
and remove
1 1.
Remove the traction cable from the traction
lever
and the left-hand control housing.
12.
Pull the tape from the outside of the handle and
remove the upper carriage bolt and the cable
lever and spacer with
it.
13.
Remove the lower carriage bolt and remove the
left control housing.
14.
Inspect all parts for wear and/or damage and
replace
as
required.
BBC Control Box Assembly
1.
Slip the lower carriage bolt through the handle
then slide the left control housing onto
it.
2.
Slip the end of the traction cable into the traction
lever then place the control housing, traction
lever, and the control bar into position
as
shown
in Figure
81. Once in position, slide the carriage
bolt through all three components.
TRACTION
Figure 81
3.
Place a piece of duct tape over the heads of the
carriage bolts that slide through the handle and
the left control box housing. This will
aid in
assembly.
4.
Slide the sleeve onto the upper carriage bolt
making sure that
it
passes through the control
bar, the traction lever and the left control housing.
5.
Position the control hook and torsion spring
in
the rocker arm as shown
i n
Figure 82. Secure
with the roll pin making sure that the roll pin is
flush with the side indicated in the Figure. Also
loosely install the BBC cable lever as indicated.
When correctly installed, the control hook and
the cable lever will be engaged.
CABLE LEVER
I
ROLL PIN FLUSH WITH THIS SIDE.
CONTROL HOOK
Figure 82
6.
Slide the rocker arm assembly over
the upper
carriage bolt and sleeve making sure that the
sleeve passes through
the cable lever. Also make
sure that the roll pin passes through the hole in
the control bar.
7.
Release the BBC cable lever from the control
hook and install the BBC cable into the cable
lever. See Figure
83.
Figure 83
8.
Slip the white nylon washer onto the J end of the
buckling spring. The slotted side of the washer
should face away from the end of the spring. Slip
the spring into position in the rocker arm and the
left control housing as shown in Figure 84.
Figure
84
BBC
50
Vacu-Power Mower
Advertisement
Table of Contents
