Rear Wheel Toe-In; Battery Care - Toro 30301TC Operator's Manual

2. Clean the area around the drain plug on rear axle.
3. Remove the check plug to ease oil draining.
4. Remove the drain plug, allowing the oil to drain into
pan.
5. Install the drain plug.
6. Fill the axle with 47 cl of Mobile 424 or until lubricant
is up to bottom of the check hole.
7. Install the check plug.
REAR WHEEL TOE-IN (Fig. 30)
After every 800 operating hours or annually, check rear
wheel toe-in.
1. Measure center-to-center distance (at axle height) at
front and rear of the steering tires. Front measurement
1
must be ⁄ in. less than rear measurement.
8
2. To adjust toe-in:
A. Remove the cotter pins and nuts securing the ball
joints to the steering arms. Separate the ball joint
from the arm.
B. Loosen the clamps at both ends of the tie rod.
C. Turn the ball joints to move the front of the tire
inward or outward.
D. Tighten the tie rod clamps when the adjustment is
correct.

BATTERY CARE

Check battery condition weekly or after every 50 hours of
operation. Keep terminals and entire battery case clean
because a dirty battery will discharge slowly. To clean the
battery, wash the entire case with solution of baking soda
and water. Rinse with clear water. Coat the battery posts
and cable connectors with Grafo 112X (skin-over) grease
(Toro Part No. 505-47) or petroleum jelly to prevent
corrosion.
2
Figure 30
1. Tie rod
2. Tie rod clamps
2
1
29