Before Operating; Check Engine Oil; Check Cooling System - Toro 30301TC Operator's Manual

Before Operating

Before servicing or making adjustments to the
machine, stop the engine and remove the key from the
switch.
Check the Engine Oil (Fig. 1 & 2)
Crankcase capacity is 4-3/4 qt. (4.5 l) with filter.
1. Park the machine on a level surface. Turn the hood
latch fully counterclockwise and open the hood.
2. Remove the dipstick and wipe it with a clean cloth.
Insert the dipstick into the tube and make sure it is fully
seated. Remove the dipstick and check the level of oil.
If the level of oil is low, add enough oil to raise the
level to the notch in the dipstick. DO NOT OVER-
FILL.
3. Install the oil fill cap.
4. Close the hood and secure the latch.
CHECK COOLING SYSTEM (Fig. 3)
System capacity is 11.5 qts. (10.9 l).
Check the cooling system if the low water level light illumi-
nates.
1. Park the machine on a level surface. Release the hood
latch and open the hood.
2. Remove the degasser tank cap and check the coolant
level. Coolant level should be up to or above the tabs in
the degasser tank when the engine is cold.
3. If the coolant is low, remove the degasser tank cap and
add a 50/50 mixture of water and Peugeot recommend-
ed anti-freeze (Toro Part No. 93-7213). DO NOT USE
WATER ONLY OR ALCOHOL/METHANOL-BASE
COOLANTS.
10
CAUTION
Figure 1
1.Hood Latch
Figure 2
1. Dipstick
2. Oil fill cap
1
Figure 3
1. Degasser tank
1
2
1