Operating Characteristics - Toro 30301TC Operator's Manual

4. After towing, pivot the lever back to its original
position and secure it.

OPERATING CHARACTERISTICS

Practice driving the GROUNDSMASTER 3000-D
because its hydrostatic transmission gives it characteris-
tics are different than many turf maintenance machines.
Some points to consider when operating the traction
unit, cutting unit, or other implement are the transmis-
sion, engine speed, load on the cutting blades or other
implement components, and the importance of the
brakes.
To maintain enough power for the traction unit and
implement while operating, use the traction pedal to
keep engine rpm high and somewhat constant. A good
rule to follow is: decrease ground speed as the load on
the implement increases, and increase ground speed as
the load decreases.
Therefore, allow the traction pedal to move backward as
engine rpm decrease, and depress the pedal slowly as
rpm increase. By comparison, when driving from one
work area to another with no load and the cutting unit
raised, have the throttle in the FAST position and
depress the traction pedal slowly but fully to attain max-
imum ground speed.
Also consider the operation of the pedals that are con-
nected to the brakes. The brakes can be used to assist in
turning the machine. However, use them carefully,
especially on soft or wet grass because the turf may be
torn accidentally.
Another benefit of the brakes is to maintain traction.
For example: in some slope conditions, the uphill wheel
slips and loses traction. If this occurs, depress the pedal
gradually and intermittently until the uphill wheel stops
slipping, thus, increasing traction on the downhill
wheel.
Use extra care when operating the machine on slopes.
Make sure the seat latch is properly secured. Drive
slowly and avoid sharp turns on slopes to prevent roll
overs. The cutting deck must be lowered when going
downhill for steering control.
This product is designed to drive objects into the
ground where they lose energy quickly in grassy areas.
However, when a person or pet appears suddenly in or
near the mowing area, STOP MOWING.
Careless operation, combined with terrain angle, rico-
chets, or improperly positioned safety guards can lead
to thrown object injuries. Do no resume mowing until
the area is cleared.
Before stopping the engine, disengage all controls and
move the throttle to SLOW. Moving the throttle to
SLOW reduces high engine rpm, noise, and vibration.
Turn the key to OFF to stop the engine.
Before transporting the machine, raise the cutting deck
and secure with transport latch.
CAUTION: This product may exceed noise levels of 85
dB(A) at the operator position. Ear protectors are recom-
mended, for prolonged exposure, to reduce the potential
of permanent hearing damage.
1
1. Transport latch
WARNING
Figure 12
19