Check Hydraulic Fluid - Toro 30301TC Operator's Manual

If the engine has been running, pressurized hot
coolant can escape and cause burns if the degasser
cap is removed. Allow the engine to cool at least 15
minutes until the degasser cap is cool enough to
touch without burning your hand.
4. Install the degasser tank cap.
5. Close the hood and secure the latch.
FILL THE FUEL TANK (Fig. 4)
Capacity of the fuel tank is 45 l.
1. Remove the fuel tank cap.
2. Fill the tank to about one inch below top of the tank,
not the filler neck with No. 2 diesel fuel. Then install
the cap.
Because diesel fuel is flammable, use caution when
storing or handling it. Do not smoke while filling the
fuel tank. Do not fill fuel the tank while engine is run-
ning, hot, or when the machine is in an enclosed area.
Always fill the fuel tank outside and wipe up any
spilled diesel fuel before starting the engine. Store
fuel in a clean, safety-approved container and keep the
cap in place. Use diesel fuel for the engine only; not
for any other purpose.
CHECK THE HYDRAULIC FLUID
(Fig. 5)
The hydraulic system is designed to operate on anti-wear
hydraulic fluid. The machine's reservoir is filled at the fac-
tory with 11.8 l of Mobil 424 hydraulic fluid. Check the
level of hydraulic fluid before the engine is first started and
daily thereafter.
1. Position the machine on a level surface, raise the imple-
ment, and stop the engine.
2. Unscrew the dipstick cap (Fig. 5) from the filler neck
and wipe it with a clean cloth. Screw the dipstick cap
CAUTION
DANGER
1
Figure 4
1. Fuel tank cap
Figure 5
1. Dipstick cap
1
11