Fuses; Preparation For Seasonal Storage - Toro 30301TC Operator's Manual

FUSES (Fig. 31)
There are four fuses in the the machine's electrical system.
They are located in compartment rear of the control panel.
PREPARATION FOR SEASONAL
STORAGE
Traction Unit
1. Thoroughly clean the traction unit, cutting units and the
engine.
2. Check the tire pressure. Inflate all tires to 103–138 kPa.
3. Check all fasteners for looseness; tighten as necessary.
4. Grease or oil all grease fittings and pivot points. Wipe
up any excess lubricant.
5. Lightly sand and use touch-up paint on painted areas
that are scratched, chipped, or rusted. Repair any dents
in the metal body.
6. Service the battery and cables as follows:
a. Remove the battery cables from the battery posts.
b. Clean the battery, posts and cable connections with
a wire brush and baking soda solution.
c. Coat the cable terminals and battery posts with
Grafo 112X skin-over grease (Toro Part No. 505-
47) or petroleum jelly to prevent corrosion.
d. Slowly recharge the battery every 60 days for 24
hours to prevent lead sulfation of the battery.
Engine
1. Drain the engine oil from the oil pan and replace the
drain plug.
2. Remove and discard the oil filter. Install a new oil fil-
ter.
3. Refill the oil pan with 4.5 l of SAE15W-40 CE motor
oil.
4. Start the engine and run at idle speed for two minutes.
30
Figure 31
1.

Fuses

STARTER
20A
HIGH
SOLENOID
TRANSPORT
COOLANT
TEMP
PTO
20A
RELAY
TRANS-
LIFT/LOWER
7.5A
CONTROL
START
RELAY
IGNITION
10A
SWITCH
1
IMPLEMENT CRUISE
FLOAT RELAY
RELAY
RELAY
(OPTIONAL)
ENGINE
SEAT
PTO
SHUTDOWN
RELAY RELAY
DELAY
RELAY